Brucella blood culture

Alphabetical Test listing

Brucella blood culture-6586 (comment "for Brucella")

Test name:

Test number:

6586 (comment "for Brucella")

Excellian order number:

87040.1

Abbreviation:

BLC

Useful for:

Aiding in confirmation of diagnosis in patient's suspected of being infected with Brucella spp.

Specimen type:

Whole blood

Collection container:

Blood culture bottles

Adult Blood culture volumes

*Blood volume drawn(venous)*	*Blood culture bottle(s)*
20 mL (Optimum)	10 mL in Lytic Anaerobic/F 10 mL in Plus Aerobic/F Note: Inoculate anaerobic bottle first to prevent entry of air from syringe. Do NOT overfill bottles (maximum: 10 mL for Aerobic and Anaerobic bottles)>
10 - 20 mL	Divide evenly between: Lytic Anaerobic/F Plus Aerobic/F
4.1 - 9 mL	Plus Aerobic/F
1.5 - 4.0 mL	Peds Plus/F (aerobic) Note: Use Peds Plus/F only in cases where it is extremely difficult to obtain a larger volume of blood, as the more blood drawn, the greater the recovery of organisms. Do NOT overfill bottle (maximum 4.0 mL/Peds bottle).
Less than 1.5 mL	Unsatisfactory for adult

Pediatric Blood culture volumes

*Pediatric patient weight*	*Blood volume drawn*	*Blood culture bottle(s)*
<4 kg	1 mL *	Peds Plus/F
4.0 - 13.9 kg	3 mL *	Peds Plus/F
14 - 24.9 kg	10 mL (Optimal)	Lytic Anaerobic/F (5 mL) Plus Aerobic/F (5 mL)
	4.1 - 9 mL	Plus Aerobic/F
	1.5 - 4.0 mL	Peds Plus/F (aerobic)
>25 kg	20 mL (Optimal)	Lytic Anaerobic/F (10 mL) Plus Aerobic/F (10 mL)
	10 - 20 mL	Divide evenly between: Lytic Anaerobic/F Plus Aerobic/F
	4.1 - 9 mL	Plus Aerobic/F
	1.5 - 4.0 mL	Peds Plus/F (aerobic)

* Less than 1 mL blood accepted, but not optimal, in patients less than 4 years of age. Note volume drawn on bottle. “Suboptimal low volume blood cultured” comment added to report.

The blood volume cultured is crucial for detection of organisms. Collect the optimum volume listed if possible. Culturing lower volumes may result in false negative results.

Volume:

20 mL (10 mL in each blood culture bottle)

Minimum volume:

4.0 mL whole blood (Peds Plus/F aerobic)

Collection instructions:

Allina Health recommends two (2) blood culture sets be collected from two (2) different peripheral sites with no delay between draws. Draw blood culture before antibiotics are administered, but do not delay antibiotics for longer than thirty (30) minutes to obtain the samples.

EACH BLOOD CULTURE SET MUST BE A SEPARATE VENIPUNCTURE. EACH SITE MUST BE PREPARED INDIVIDUALLY, even if more than one blood culture is to be drawn at the same time.

Remove FLIP OFF cap of each bottle.
Sterilize the exposed rubber septum using a 70% alcohol prep.
Apply tourniquet to patient's arm and select vein.
Prepare venipuncture site.
1. Hold the ChloraPrep SEPP applicator with sponge tip facing downward and gently squeeze to break the ampule. Do not touch the tip.
2. Saturate the tip with ChloraPrep by gently pressing it against the treatment area.
3. Using a back and forth friction scrubbing motion, completely wet the treatment area for 30 seconds.
4. Allow the prepped area to dry completely, approximately 30 seconds.

Do not blot or wipe the solution away, or fan or blow on the site, as this may result in contamination of the blood culture.

5. Discard the applicator after a single use.

6. Blood must be drawn with a syringe and butterfly or a syringe and needle. The vacuum in the Bactec bottles is not predictable and the volume markings on the bottles are inaccurate, so do NOT draw the blood directly into the bottle.

SPS vacutainer tubes or Isolator tubes should NOT be used to draw the blood, as the additional anticoagulants in these tubes may be detrimental to organism recovery.

After the venipuncture site has been disinfected, the vein may not be palpated again. If further palpation of the vein is necessary during aspiration, a sterile glove should be worn.
Withdraw 20 mL blood.

For pediatric patients, see Pediatric Blood Culture Volume chart.

Release tourniquet, place gauze on the needle, and withdraw the needle from the vein while gently compressing the gauze.
DISCARD NEEDLE AND ATTACH BD BLOOD TRANSFER DEVICE TO SYRINGE. (Utilize one Transfer Device to inject both bottles.)
Inject 10 mL of blood into the Lytic Anaerobic/F bottle first to prevent entry of air from the syringe. Then inject 10 ml of blood into the Plus Aerobic/F bottle.

Inoculation of greater than 10 mL blood into the Aerobic or Anaerobic bottle or more than 4 mL into the Peds Plus/F bottle may result in suboptimal blood to media ratios and possible false negative results.

After thoroughly mixing contents by gently inverting bottles, label the bottle with two unique patient identifiers, time of collection and site
1. Do NOT cover sensor on bottom of bottle.
2. Do NOT cover or write over teh bottle barcode.

Processing instructions:

Submit entire specimen

Transport container:

Blood culture bottles

Transport and stability:

Ambient (strict) - 48 hrs

Refrigerated - NO

Frozen - NO

Reason for rejection:

Improper label (unlabeled or mislabeled)
Time delay between time of collection and receipt of specimen
Improper transport container
Improper transport temperature
Inappropriate specimen type
Leaking container

Performing lab:

AHL - Microbiology: M

Days set up:

Daily

TAT:

4 weeks

Method:

Culture

Reference ranges:

No Brucella isolated

Clinical information:

Identification, susceptibilities and serogrouping will be performed on all microbiology isolates considered by the laboratory to be significant.

CPT codes:

87040

Additional CPT codes (if appropriate):
87186 - Sensitivities
87077 - ID

This list may not be all inclusive if there is the need to send the ID or sensitivities out to a referral laboratory

Date created:

01/10/2008

Revised date:

12/26/2023

Review date:

12/18/2023